Raptor Buckle Gen1 – discontinued

Discontinued. Replaced with Gen2 Raptor.

By purchasing the purchaser attests that they possess the necessary training and authorization to properly use this product. The purchaser assumes all liability for events arising from the use of this product and will not hold Mission Spec civilly or criminally liable.

Buckles sizes reference the size of webbing they are made to interface with. A 1.5″ Raptor is made to work with 1.5″ webbing. The indicated size DOES NOT pertain to the overall size of the buckle.

Manufactured by American Direct Fabrication for JBC CORP. in the United States with a Limited Lifetime Warranty from JBC. Currently, Mission Spec is the only retailer where the Raptor Buckle can be purchased as the buckle alone (not attached to another piece of gear).

Sizes available: 1″, 1.5″, 1.75″, 2″
Colors Available: Matte Black, Coyote Tan, Olive Drab (OD) Green.

  • Made in the U.S.A
  • 7075 Aluminum
  • Berry Compliant (see: Berry Amendment USC, Title 10, Section 2533a).
  • Exceeds NFPA 1983 Section 3.2.1.6 (load bearing test)
  • Exceeds MIL-STD-810F (salt spray and blowing sand/dust)

Load bearing data
kN rating refers to a looped pull test configuration. A single strand configuration would theoretically hold 50% of the load rating. Both ratings are stamped directly onto the Raptor Buckle.

1″ (25mm) – 1.7oz – 12kN/2,697 lbf. – Pulled to destruction and broke at 16.5 kN / 3,716 lbf.

1.5″ (38mm) – 2.5oz – 18 kN/4,046 lbf. – Pulled to destruction and broke at 27.6 kN / 6,212 lbf.

1.75″ (45mm) – 2.6oz – 18 kN/4,046 lbf. – Pulled to destruction and broke at 24.4 kN / 5,489 lbf.

2″ (50mm) – 2.8oz – 18 kN/4,046 lbs. – Pulled to destruction and broke at 27.6 kN / 6,222 lbf.

Comments are closed.